Figure 6-4 Installing An Extension Board - Hitachi HF-W2000 58 Instruction Manual

6. INSPECTION AND MAINTENANCE
[3] Remove the cable from the cable clips, and move it to the side.
[4] Remove the two screws that are securing the expansion slot.
[5] Remove the expansion slot by lifting it directly upward.
[6] Remove the screw securing the extension board, and then remove the slot cover. (Store the slot cover so that it
will not become lost.)
[7] While pressing on both ends of the extension board, insert the extension board horizontally into the expansion
slot connector.
[8] Press directly above the extension board connector to fully insert the extension board into the expansion slot
connector.
[9] Restore the equipment by following the procedure in reverse, and then install the PCI cover.
[10] Install the cover of the main unit for the equipment.
NOTE
When you install an extension board, adjacent boards might become loose. Verify that all adjacent board are fully
inserted.
Extension board
[7]
[4] Expansion slot securing screws (2)

Figure 6-4 Installing an extension board

6-10
[7]
[8]
[6] Securing screws (1 for each slot)
[3] Cable clips