Installing And Removing The Cover Of The Main Unit; Figure 6-2 Removing The Cover Of The Main Unit - Hitachi HF-W2000 58 Instruction Manual

6.3.3 Installing and removing the cover of the main unit

When installing the cover of the main unit, do not insert your fingers into the inside of the
cover of the main unit. Doing so might result in your fingers getting caught, causing injury.
Before starting work, see 6.3.2 Before installing or removing components.
(1) Removing the cover of the main unit
[1] Remove the three screws on the rear of the equipment.
[2] Slide the cover towards the rear of the equipment.
[3] Pull the sides of the cover apart slightly from the body of the equipment, and then lift the cover up and away.
(2) Installing the cover of the main unit
When installing the cover of the main unit, reverse the procedure described in (1) Removing the cover of the main
unit. Then, install the center screw first, as shown in Figure 6-2.
CAUTION
[1]

Figure 6-2 Removing the cover of the main unit

6. INSPECTION AND MAINTENANCE
Note: When installing the cover of the main unit,
[1]
install this screw first.
6-7
[1]
[3]
[2]