Table 1-1 Function Of Each Part - Hitachi HF-W2000 58 Instruction Manual

Name
Power switch (POWER)
NMI switch
Status lamp (STATUS)
Alarm lamp (ALARM)
Drive access lamp
(DRIVE)
Standby lamp (STBY)
DRIVE status lamps
DRIVE1:
For drive bay 1
DRIVE2:
For drive bay 2
(B model only)

Table 1-1 Function of each part (1/5)

Pressing this switch turns the power on. If you press the switch for four seconds or
more, the power turns off, and the system goes into standby mode (for emergencies
only).
This switch is used to collect memory dumps.
If you press the switch while the OS is running, a memory dump is performed. If
you press the switch again after the memory dump is performed, the hardware is
reset.
Lamp
Lit in green The equipment is operating (RUN status).
Lit in red The equipment is not operating (STOP status):
• The equipment is starting up.
• An equipment shutdown has started or an error stop
occurred.
• The equipment has stopped abnormally due to an error.
• RAS software is not installed.
Off The main power is off or the system is in standby mode.
This lamp is lit in red if one of the following abnormalities is detected:
• A fan inside the equipment has stopped.
• The inside of the equipment is at an abnormal temperature.
• A failure occurred in one of the mirrored disks (B model only).
This lamp is lit in green while an HDD, SSD, or DVD drive is being accessed.
Lamp
Lit in orange The equipment is in standby mode (only the auxiliary power
is on).
Off The power is shutdown or the equipment is operating.
Lamp
Off No problems are detected.
Lit in red An HDD is offline (the power of the HDD is off).
Blinking red A rebuild (copy) is in progress. Only the lamp of the copy
(either one) destination HDD blinks.
Blinking red Both HDDs are offline.
(both)
1-7
1. GETTING STARTED
Function
Status
Status
Status