Figure 6-5 Removing An Extension Board - Hitachi HF-W2000 58 Instruction Manual

(4) Removing an extension board
[1] Follow the instructions in 6.3.3 Installing and removing the cover of the main unit to remove the cover of the
main unit and the PCI cover.
[2] Remove the cable from the cable clips, and move it to the side.
[3] Remove the two screws that are securing the expansion slot.
[4] Remove the expansion slot by lifting it directly upward.
[5] Remove the screw securing the extension board, and then remove the slot cover.
[6] While holding the top of the extension board connector, pull out the extension board horizontally from the
expansion slot connector.
[7] Use a screw to secure the stored slot cover over the empty expansion slot.
[8] Restore the equipment by following the procedure in reverse, and then install the PCI cover.
[9] Install the cover of the main unit for the equipment.
Always install a slot cover over each unused expansion slot. Not doing so might result in
equipment failure.
Extension board
[6]
[3] Expansion slot securing screws (2)

Figure 6-5 Removing an extension board

[6]
[5] [7] Securing screws (1 for each slot)
NOTICE
6-11
6. INSPECTION AND MAINTENANCE
[2] Cable clips