Siemens SINUMERIK 840D sl Programming Manual page 104

Measuring variants
2.3 Measure workpiece (milling)
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 12)
(only for measuring without
spindle reversal)
Spindle Measuring with 180° spindle
reversal reversal
Yes

No

Parameters
Correction target
Angular offset
(only for "work offset")
Positioning
Measuring direction
Positioning axis
α
L2
Protection zone
104
Unit
-
-
-
Description
Measuring only (no offset)

Work offset (save measured values in an adjustable WO)

Offset results in:
Coordinate system rotation

Rotary axis rotation C

Position probe:
Parallel to the axis

Parallel to the edge

Measuring axis
(+/-) X

(+/-) Y

(+/-) Z

Offset axis (Note: Measuring axis and offset axis may not be the same!)
X

Y

Z

Angle between positioning axis and edge
Distance to the 2nd measuring point
Use protection zone
Yes

No

ShopMill program
Parameters
T
D
Spindle
reversal
X
Y
Z
4)
1)
2)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 12)
(only for measuring without
spindle reversal)
Measuring with 180° spindle
reversal
Yes

No

Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
3)
Unit
-
-
-
-
mm
mm
mm
Unit
-
-
-
-
-
Degrees
mm
-
Measuring cycles