Siemens SINUMERIK 840D sl Programming Manual page 128

Measuring variants
2.3 Measure workpiece (milling)
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19) -
Calibration data set (1 - 12)
Parameters Description
Correction
Measuring only (no offset)

target
Work offset (save measured values in an adjustable WO)

Tool offset (save measured values in the tool data)

TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
∅ Hole diameter setpoint
α0 Angle between measuring axis and workpiece
Protection Use protection zone
zone
Yes

No

∅S Diameter of the protection zone (only for protection zone "Yes")
LS Length of the protection zone (only for protection zone "Yes")
DX / DY / DZ Infeed distance at measuring height (only for protection zone "Yes")
DFA Measurement path
TSA Safe area for the measurement result
Dimensional Use dimensional tolerance for tool offset
tolerance
Yes

No

TUL Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
128
Unit
-
Machine manufacturer
Please observe the machine manufacturer's instructions.
ShopMill program
Parameters Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 12)
X Start point X of the measurement
Y Start point Y of the measurement
Z Start point Z of the measurement
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
mm
mm
mm
Unit
-
-
-
mm
Degrees
-
mm
mm
mm
mm
mm
-
mm
mm
Measuring cycles