Siemens SINUMERIK 840D sl Programming Manual page 69

Parameters
G code program
Parameters Description
Calibration data set (1 - 12)
Parameters Description
Correction target



TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
Z0 Reference point Z
DFA Measurement path
TSA Safe area for the measurement result
Dimensional Use dimensional tolerance (only for the "Tool offset" correction target)
tolerance


TUL Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
Measuring only (no offset)
Work offset (save measured values in an adjustable WO)
Tool offset (save measured value in the tool data)
Yes
No
Machine manufacturer
Please observe the machine manufacturer's instructions.
ShopTurn program
Parameters Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 12)
β Tool alignment with swivel axis


Value entry

Z Start point Z of the measurement
X Start point X of the measurement
Y Start point Y of the measurement
1)
Measuring variants
2.2 Measure workpiece (turning)
Unit
-
-
-
Degrees
(0 degrees)
(90 degrees)
mm
mm
mm
Unit
-
-
-
mm
mm
mm
-
mm
mm
69