Siemens SINUMERIK 840D sl Programming Manual page 231

No. Screen form Cycle
parameters parameters
_DMODE
19
20 _AMODE
All default values = 0 or marked as default=x
1)
Display depends on the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE
2)
WO "fine"only if correction target is rotary axis and MD52207 $MCS_AXIS_USAGE_ATTRIB[n] Bit6=1.
3)
If WO has not been set up in MDs, correction is according to WO "coarse".
Example for offset in coordinate rotation:
4)
Z (for G17)
Value only relevant for protection zone "Yes" (
5)
When positioning from measuring point P1 to measuring point P2 in the offset axis, the angles in parameters
6)
and are added.
S_TSA
Number of the measuring axis must not be the same as the number of the offset axis (e.g. 101 not permitted)
7)
Measuring direction only for "Align edge" and "Measurement paraxial" (
8)
Angular range
9)
S_STA1 ±
Angular range
S_STA1
For measuring versions "Align plane" and "Align edge"
10)
For measuring variant "Measure plane" and "Measurement paraxial"
11)
Not for measuring cycle version SW04.04.
12)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Display mode
Values: UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Reserved (alternative mode)
S_MA=102
S_MVAR
45 degrees for "Align edge"
0 to +60 degrees and
S_INCA ±
3.1 Overview of measuring cycle parameters
Measuring axis Y, offset axis X results in coordinate rotation around
THOUSANDS position = 1)
S_MVAR=10x105
30 degrees for "Align plane"
Parameter lists
S_STA1
)
231