Cycle998 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

3.1.6

CYCLE998 measuring cycle parameters

PROC CYCLE998(INT S_MVAR,INT S_KNUM,INT S_RA,INT S_PRNUM,REAL S_SETV,REAL S_STA1,REAL
S_INCA,REAL S_FA,REAL S_TSA,INT S_MA,INT S_MD,REAL S_ID,REAL S_SETV0,REAL S_SETV1,REAL
S_SETV2,REAL S_SETV3,INT S_NMSP,INT S_MCBIT,INT _DMODE,INT _AMODE) SAVE ACTBLOCNO DISPLOF
Table 3- 6 CYCLE998 call parameters
No. Screen form Cycle
parameters parameters
1 S_MVAR
2 Selection S_KNUM
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
1)
Meaning
Measuring variant (default=5)
Values: UNITS: Contour element
5 = Measure edge (one angle)
6 = Measure plane (two angles)
TENS: Reserved
HUNDREDS: Correction target
0 = Only measurement and no correction of WO
1 = Measurement, determination and correction of the WO (see
THOUSANDS: Protection zone
0 = No consideration of a protection zone
1 = Consideration of a protection zone
TEN THOUSANDS: Measurement with spindle reversal (difference
measurement)
0 = Measurement without spindle reversal
1 = Measurement with spindle reversal
HUNDRED THOUSANDS: Measurement at an angle or paraxial
0 = Measurement at an angle
1 = Measurement paraxial
Correction of the work offset (WO) or basic WO or basic reference
Values: UNITS:
TENS:
0 = No correction
1 to max. 99 numbers of the work offset or
1 to max. 16 numbers of the basic offset
HUNDREDS: Reserved
THOUSANDS: Correction of WO or basic or basic reference
0 = Correction adjustable WO
1 = correction, channel-specific basic WO
2 = correction basic reference
9 = Correction active WO and/or for G500 in last active channel-specific basic
WO
TEN THOUSANDS: Coarse or fine correction in the WO or basic WO or basic
reference
3)
0 = Correction fine1 = correction coarse
3.1 Overview of measuring cycle parameters
Parameter lists
)
S_KNUM
2)
229