Siemens SINUMERIK 840D sl Programming Manual page 113

List of the result parameters
The measuring variant "Rib" provides the following result parameters:
Table 2- 16
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Rib" result parameters
Description
Rib width setpoint
Rib center setpoint in the 1st axis of the plane
Rib center setpoint in the 2nd axis of the plane
Rib width actual value
Rib center actual value in the 1st axis of the plane
Rib center actual value in the 2nd axis of the plane
Rib width difference
Rib center difference in the 1st axis of the plane
Rib center difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Measuring version
Tool name
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
113