Siemens SINUMERIK 840D sl Programming Manual page 187

Measuring "axis by axis" - only length (L1 or L2)
Length L1 or L2 is measured in the parameterized measuring axis.
Table 2- 33 Measuring "axis by axis" - only length (L1 or L2)
Measuring length L2
Measuring "axis by axis" - only radius
The radius in the parameterized measuring axis is measured by probing twice at the probe.
Table 2- 34
Without milling tool reversal
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Without milling tool reversal
Measuring length L1
Measuring "axis by axis" - only radius
2.4 Measure tool (turning)
With milling tool reversal
Measuring length L1
Precondition: Radius R must be known.
With milling tool reversal
Measuring variants
187