Siemens SINUMERIK 840D sl Programming Manual page 239

No Screen form Cycle
. parameters parameters
S_KNUM1
3 Selection
S_PRNUM
4 Icon+
number
5 X0 S_SETV
6 DFA S_FA
7 TSA S_TSA
S_CPA
8 X0
9 Y0 S_CPO
10 Alpha 0 S_STA1
11 Alpha 1 S_INCA
S_NMSP
12 Measureme
nts
13 T S_TNAME
14 DL S_DLNUM
15 TZL S_TZL
S_TDIF
16 DIF
17 TUL S_TUL
18 TLL S_TLL
19 TMV S_TMV
S_K
20 FW
21 S_EVNUM
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Correction in tool offset
2)
Values: UNITS:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset; for additive and
setup offset, see also
THOUSANDS: Reserved
TEN THOUSANDS: Tool offset
0 = No specification (offset in tool radius normal, not inverted)
1 = Offset inverted
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool radius)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
MILLIONS: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
Number of the field of the probe parameter (not probe number)
(value range 1 to 12)
Setpoint
Measurement path
Safe area
Center point of the 1st axis of the plane (for G17 X)
Center point of the 2nd axis of the plane (for G17 Y)
Starting angle
7)
Incremental angle
8)
Number of measurements at the same location
Tool name
2)
Setup additive offset DL number
Work offset
1), 2)
Dimensional difference check
Upper tolerance limit
3)
Lower tolerance limit
3)
Offset range for averaging
Weighting factor for averaging
Date set, empirical value memory
3.1 Overview of measuring cycle parameters
S_DLNUM
2)
2)
2)
5)
5)
5)
1)
1), 4)
1), 2)
1)
1)
1), 6)
Parameter lists
239