Siemens SINUMERIK 840D sl Programming Manual page 144

Measuring variants
2.3 Measure workpiece (milling)
Procedure
The part program or ShopMill program to be processed has been created and you are in the
editor.
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 12)
Parameters Description
Correction target



TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
Qty. measuring Measurement with:
points


∅ Diameter of spigot
XM Center point X (for measuring plane G17)
YM Center point Y (for measuring plane G17)
α0 Starting angle
α1 Incrementing angle
DFA Measurement path
TSA Safe area for the measurement result
Dimensional Use dimensional tolerance for tool offset
tolerance


144
1. Press the "Meas. workpiece" softkey.
2. Press the "Spigot" softkey.
3. Press the "Outer circle segment" softkey.
The input window "Measure: Outer circle segment" is opened.
Unit
-
-
Measuring only (no offset)
Work offset (save measured values in an adjustable WO)
Tool offset (save measured values in the tool data)
3 points
4 points
Yes
No
ShopMill program
Parameters Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 12)
X Start point X of the measurement mm
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
Unit
-
-
-
-
mm
mm
mm
Degrees
Degrees
mm
mm
-
Measuring cycles