Siemens SINUMERIK 840D sl Programming Manual page 112

Measuring variants
2.3 Measure workpiece (milling)
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 12)
Parameters Description
Correction target



TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
Measuring axis Measuring axis (for measuring plane G17)


W Rib width setpoint
α0 Angle between measuring axis and workpiece
DZ Infeed distance at measuring height (for measuring plane G17)
Protection zone Use protection zone


WS Width of the protection zone (only for protection zone "Yes")
DFA Measurement path
TSA Safe area for the measurement result
Dimensional Use dimensional tolerance for tool offset
tolerance


TUL Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
112
Unit
-
-
Measuring only (no offset)
Work offset (save measured values in an adjustable WO)
Tool offset (save measured values in the tool data)
X
Y
Yes
No
Yes
No
Machine manufacturer
Please observe the machine manufacturer's instructions.
ShopMill program
Parameters Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 12)
X Start point X of the measurement
Y Start point Y of the measurement
Z Start point Z of the measurement
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
mm
mm
mm
Unit
-
-
-
-
mm
Degrees
mm
-
mm
mm
mm
-
mm
mm
Measuring cycles