Siemens SINUMERIK 840D sl Programming Manual page 125

List of the result parameters
The measuring variant "Rectangular pocket" provides the following result parameters:
Table 2- 19
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVI [0]
_OVI [2]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Rectangular pocket" result parameters
Description
Rectangle length setpoint in the 1st axis of the plane
Rectangle length setpoint in the 2nd axis of the plane
Rectangle center point setpoint in the 1st axis of the plane
Rectangle center point setpoint in the 2nd axis of the plane
Rectangle length actual value in the 1st axis of the plane
Rectangle length actual value in the 2nd axis of the plane
Rectangle center point actual value in the 1st axis of the plane
Rectangle center point actual value in the 2nd axis of the plane
Rectangle length difference in the 1st axis of the plane
Rectangle length difference in the 2nd axis of the plane
Rectangle center point difference in the 1st axis of the plane
Rectangle center point difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Tool name
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
125