Drill (Cycle982) - Siemens SINUMERIK 840D sl Programming Manual

2.4.5

Drill (CYCLE982)

Function
With this measuring version, the tool length (L1 or L2) of a drill can be measured. The
measuring version checks whether the difference to be corrected with respect to the old tool
length lies within a defined tolerance range:
● Upper limits: Safe area TSA and dimensional difference control DIF
● Lower limit: Work offset range TZL
If this range is not violated, the new tool length is accepted in the tool offset, otherwise an
alarm is output. Violation of the lower limit is not corrected.
Measuring principle
The length (L1 or L2) of the drill is measured in the parameterized measuring axis.
Measuring length L2
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
2.4 Measure tool (turning)
Measuring length L1
Measuring variants
193