Position after the end of the measuring cycle
The probe is at a distance of the measuring path (DFA) from the measuring surface, above
the turning center.
When "Travel under the center of rotation" is selected, after the end of the measuring cycle,
the probe is at a distance of the measuring path (DFA) from the measuring surface, below
the center of rotation.
Procedure
The part program or ShopTurn program to be processed has been created and you are in
the editor.
Parameters
G code program
Parameters Description
Calibration data set (1 - 12)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
1. Press the "Meas. workpiece" softkey.
2. Press the "Turning measurement" softkey.
3. Press the "Inside diameter" softkey.
The input window "Measure: inside diameter" is opened.
ShopTurn program
Unit
Parameters Description
-
T
D
β
Z
X
2.2 Measure workpiece (turning)
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 12)
Tool alignment with swivel axis
(0 degrees)
(90 degrees)
Value entry
Start point Z of the measurement mm
Start point X of the measurement mm
Measuring variants
Unit
-
-
-
Degrees
73