Cycle996 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists
3.1 Overview of measuring cycle parameters
3.1.11

CYCLE996 measuring cycle parameters

PROC CYCLE996(INT S_MVAR,INT S_TC,INT S_PRNUM,REAL S_SETV,REAL S_STA1,REAL S_SETV0,REAL
S_SETV1,REAL S_SETV2,REAL S_SETV3,REAL S_SETV4,REAL S_SETV5,REAL S_TNVL,REAL S_FA,REAL
S_TSA,INT S_NMSP,INT S_MCBIT,INT _DMODE,INT _AMODE) SAVE SBLOF ACTBLOCNO DISPLOF
Table 3- 11 CYCLE996 call parameters
No. Screen form Cycle
parameters parameters
1 S_MVAR
244
1)
Meaning
Measuring version (default=1)
Values: UNITS: Measuring sequence
0 = Calculate kinematics (selection with: Result display, protocol, change of
the swivel data sets, where relevant with operator acknowledgment), see
_AMODE
1 = 1st measurement
2 = 2nd measurement
3 = 3rd measurement
TENS: Reserved
0 = 0
HUNDREDS: Measuring variant for 1st to 3rd measurement
0 = Measurement of the calibration sphere paraxial
1 = Measurement of the calibration sphere at an angle and no spindle
reversal
3)
2 = Measurement of the calibration sphere and correction of the spindle in the
switching direction of the probe
THOUSANDS: Calculate correction target for kinematics
0 = measuring only. Swivel data sets are calculated, but remain unchanged
1 = calculate swivel data set. Swivel data sets are, if necessary, changed
after acknowledgment by the operator
TEN THOUSANDS: Measuring axis (rotary axis 1 or 2) or vector chain open
or closed for calculate kinematics
0 = Vector chain closed (only for calculate kinematics)
1 = Rotary axis 1 (only for 1st to 3rd measurement)
2 = Rotary axis 2 (only for 1st to 3rd measurement)
3 = Vector chain open (only for calculate kinematics)
HUNDRED THOUSANDS: Normalizing of rotary axis 1 for calculate
kinematics
0 = No normalizing of rotary axis 1
1 = Normalizing in direction of 1st axis of the plane (for G17 X)
2 = Normalizing in direction of 2nd axis of the plane (for G17 Y)
3 = Normalizing in direction of 3rd axis of the plane (for G17 Z)
MILLIONS: Normalizing of rotary axis 2 for calculate kinematics
0 = No normalizing of rotary axis 2
1 = Normalizing in direction of 1st axis of the plane (for G17 X)
2 = Normalizing in direction of 2nd axis of the plane (for G17 Y)
3 = Normalizing in direction of 3rd axis of the plane (for G17 Z)
3)
4)
5)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
4)
5)
Measuring cycles