Siemens SINUMERIK 840D sl Programming Manual page 98

Measuring variants
2.3 Measure workpiece (milling)
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19) -
Calibration data set (1 - 12)
(only for measuring without
spindle reversal)
Spindle Measuring with 180° spindle
reversal reversal
Yes

No

Parameters Description
Correction
Measuring only (no offset)

target
Work offset (save measured value in an adjustable WO)

Tool offset (save measured value in the tool data)

TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
Measuring Measuring axis
direction
+/- X

+/- Y

+/- Z

X0 / Y0 / Z0 Setpoint (corresponding to the measuring direction)
DFA Measurement path
TSA Safe area for the measurement result
Dimensional Use dimensional tolerance for tool offset (only for the "Tool offset" correction target)
tolerance
Yes

No

TUL Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE.
1)
98
ShopMill program
Unit Parameters
T
D
-
- Spindle
reversal
X
Y
Z
Machine manufacturer
Please observe the machine manufacturer's instructions.
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 12)
(only for measuring without spindle
reversal)
Measuring with 180° spindle
reversal
Yes

No

Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
-
mm
mm
mm
Unit
-
-
-
-
mm
mm
mm
-
mm
mm
Measuring cycles