Index - Siemens SINUMERIK 840D sl Programming Manual

Index

C
Calculation of center point and radius of a circle, 44
Calculation of the deceleration distance, 32
Calibration tool, 29
compensation value calculation, 35
CYCLE116, 44
D
Dimension difference check, 39
Dimensional deviations, 35
E
Effect of empirical value, mean value, and tolerance
parameters, 43
F
Flying measurement, 30
L
Lower tolerance limit, 39
M
Mean value, 35
Mean value calculation, 35
Measure tool (milling)
Calibrate, 202
Measure, 208
Measure tool (turning)
Calibrate, 178
Measure, 182, 186, 193
Measure workpiece (milling)
Calibrate, 83, 86, 90
Calibrate on ball (CYCLE976), 93
Measure, 96, 100, 106, 110, 114, 118, 122, 126,
130, 134, 138, 142, 146, 150, 154, 159
Measure workpiece (turning)
Calibrate, 57, 60, 63
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Measure, 67, 71, 76
Measurement result display, 47
Measuring cycle support in the program editor (from
SW 6.2), 46
Measuring accuracy, 33
Measuring cycle parameters
CYCLE961, 235
CYCLE971, 250
CYCLE973, 215
CYCLE974, 218
CYCLE976, 224
CYCLE977, 232
CYCLE978, 226
CYCLE979, 238
CYCLE982, 247
CYCLE994, 221
CYCLE996, 244
CYCLE997, 241
CYCLE998, 229
Measuring strategy, 35
Measuring velocity, 32
Menu tree
Milling technology, 53
Turning technology, 51
P
Parameters for checking the measurement result and
offset, 38
Probe, 18
L probe, 20
Mono probe, 20
Multi probe, 20
Star probe, 21
Tool probe, 18
Workpiece probe, 19
Probes that can be used, 18
R
Reference points at machine and workpiece, 13
Result parameters, 55
S
Safe area, 38
Starting position/Setpoint position, 31
279