Siemens SINUMERIK 840D sl Programming Manual page 117

List of the result parameters
The measuring variant "Right-angled corner" provides the following result parameters:
Table 2- 17
Parameters
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [20]
_OVR [21]
_OVR [22]
_OVI [2]
_OVI [3]
_OVI [5]
_OVI [9]
1)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Right-angled corner" result parameters
Description
Angle actual value to the 1st axis of the plane in the workpiece
coordinate system (WCS)
Corner point actual value in the 1st axis of the plane in the WCS
Corner point actual value in the 2nd axis of the plane in the WCS
Angle actual value to the 1st axis of plane in the machine coordinate
system (MCS)
Corner point actual value in the 1st axis of the plane in the MCS
Corner point actual value in the 2nd axis of the plane in the MCS
Measuring cycle number
Measuring version
Probe number
Alarm number
For deactivated transformation, otherwise basic coordinate system
1)
Measuring variants
2.3 Measure workpiece (milling)
Unit
Degrees
mm
mm
Degrees
mm
1)
mm
1)
-
-
-
-
117