Siemens SINUMERIK 840D sl Programming Manual page 65

Procedure
The part program or ShopTurn program to be processed has been created and you are in
the editor.
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 12)
F Calibration and measuring
feedrate
Parameters
Calibrate
Calibration directions
(only for "Radius" calibration)
Measuring direction
Adapt tool length
(only for "Length" calibration)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
1. Press the "Meas. workpiece" softkey.
2. Press the "Calibrate probe" softkey.
3. Press the "Calibrate in groove" softkey.
The input window "Calibrate: probe in groove" is opened.
Unit
-
-
Distance/
min
Description
Length (calibrate probe length)

Radius (calibrate probe radius)

1: Calibration in one direction

2: Calibration in opposite directions

Measuring axis (corresponding to the measuring plane):
(+/-) Z

(+/-) X

No (adapt trigger point only)

Yes (adapt probe length and trigger point)

ShopTurn program
Parameters Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 12)
β Tool alignment with swivel axis


Value entry

F Calibration and measuring
feedrate
X Start point X of the measurement mm
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
Measuring variants
2.2 Measure workpiece (turning)
Unit
-
-
-
Degrees
(0 degrees)
(90 degrees)
mm/min
Unit
-
-
-
-
65