Siemens SINUMERIK 840D sl Programming Manual page 249

No. Screen form Cycle
parameters parameters
_AMODE
18
All default values = 0 or marked as default=x
1)
Display depends on the general SD 54762 _MEA_FUNCTION_MASK_TOOL
2)
Measure turning or milling tool or drill. Measuring axis in parameter
3)
Specification for turning tools via cutting edge position 1...8, for milling tools via HUNDREDS to THOUSANDS position
in parameter .
S_MVAR
Measurement and calibration are performed in the basic coordinate system (MCS for kinematic transformation switched
4)
off).
Not for incremental measuring
5)
Only for multiple measurements
6)
If the channel-specific SD 42950 $SC_TOOL_LENGTH_TYPE = 2, then the tool length components are assigned just
7)
the same as for turning tools
Only for measurement with reversal
8)
Empirical value generation
9)
Value range of the empirical value memory: 1 to 20 numbers (n) of the empirical value memory, see channel-specific
SD 55623 $SCS_MEA_EMPIRIC_VALUE[n-1].
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Alternative mode
or (example, disk-type or groove milling tools)
S_MVAR=x2x02 x3x02
S_MVAR=xx1x1
3.1 Overview of measuring cycle parameters
S_MA
Parameter lists
249