Siemens Sinumerik 840D sl Function Manual page 426

Sinumerik safety integrated
Hide thumbs Also See for Sinumerik 840D sl:
Table of Contents

Advertisement

Data Description
8.1 Machine data for SINUMERIK 840D sl
37906
MD number
Default value: 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
Special cases, errors,...
37907
MD number
Default value: 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
Special cases, errors,...
8-426
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
$MA_SAFE_CAM_RANGE_BIN_OUTPUT_1[0...14]
Output assignment, cam range bit for cam track 1
Min. input limit: 0
Protection level: 7/2
This machine data specifies the outputs for the cam range bits of cam track 1.
Structure: see coding of the output assignment, see Page 8-417
Field index n corresponds to the parameterizable cam range numbers on cam track 1.
The cam range number is defined using the following machine data:
MD36938 $MA_SAFE_CAM_TRACK_ASSIGN[0...29]
Signal means
= 0, axis is not located on the cam with cam range number n
= 1, axis is located on the cam with cam range number n
Example:
The signal that is addressed using field index 5 goes to 1 if the axis is located at the cam
that is assigned to cam track 1 by parameterizing the cam range number 5.
Note:
The "safe cam track" function is enabled using MD36903 $MA_SAFE_CAM_ENABLE.
If the cam range number n is not parameterized on cam track 1 then the signal of field index
n can never go to 1. The output MD with field index n must in this case not be para-
meterized.
$MA_SAFE_CAM_RANGE_BIN_OUTPUT_2[0...14]
Output assignment, cam range bit for cam track 2
Min. input limit: 0
Protection level: 7/2
This machine data specifies the outputs for the cam range bits of cam track 2.
Structure: see coding of the output assignment, see Page 8-417
Field index n corresponds to the parameterizable cam range numbers on cam track 2.
The cam range number is defined using the following machine data:
MD36938 $MA_SAFE_CAM_TRACK_ASSIGN[0...29]
Signal means
= 0, axis is not located on the cam with cam range number n
= 1, axis is located on the cam with cam range number n
Example:
The signal that is addressed using field index 5 goes to 1 if the axis is located at the cam
that is assigned to cam track 2 by parameterizing the cam range number 5.
Note:
The "safe cam track" function is enabled using MD36903 $MA_SAFE_CAM_ENABLE.
If the cam range number n is not parameterized on cam track 2 then the signal of field index
n can never go to 1. The output MD with field index n must in this case not be para-
meterized.
Max. input limit: 84020620
Unit: - -
Max. input limit: 84020620
Unit: - -
© Siemens AG 2015 All Rights Reserved
10/15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics s120

Table of Contents