Siemens Sinumerik 840D sl Function Manual page 554

Commissioning
9.1 Pictures of the user interface and softkeys
Settings
You can select the safety functions by pressing softkey "Settings" (Fig.9-2).
Figure 9-5 Settings -- options
S In the "Settings -- Options" window you can select and enable the safety
functions.
S The "Evaluation factors to determine the setpoint limits" can only be activated
when an extended safety function has been set. This option can also be defined
if the commissioning mode is not active.
You can directly enter the evaluation factors as a percentage in the input fields.
Alternatively, you can go to a subsequent dialog by pressing the "Recom-
mended values" softkey. Here, the axis machine data is always preassigned
80 % and the drive parameters 100 %. You can accept these recommended
values by pressing the "Yes" softkey. You can exit the dialog with "No" without
accepting the values.
S Reaction of the stop response
For NC axes you can define the reaction of the stop response here.
9-554
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
© Siemens AG 2015 All Rights Reserved
10/15