Pioneer PE6000 Series User Manual page 134

Description of Function Codes
If the AC drive running frequency is within the certain range of the set frequency, the
corresponding DO terminal becomes ON.
This parameter is used to set the range within which the output frequency is detected to reach
the set frequency. The value of this parameter is a percentage relative to the maximum frequency.
The detection range of frequency reached is shown in the following figure.
Figure 5-17 Detection range of frequency reached
Jump frequency during
acceleration/deceleration
P8-22
Setting Range
It is used to set whether the jump frequencies are valid during acceleration/deceleration.
When the jump frequencies are valid during acceleration/deceleration, and the running
frequency is within the frequency jump range, the actual running frequency will jump over the set
frequency jump amplitude. The following figure shows the diagram when the jump frequencies are
valid during acceleration/deceleration.
Figure 5-18 Diagram when the jump frequencies are valid during acceleration/deceleration
Default
0
0
134
PE6000 User Manual
0
Disabled
Enabled