Use Of Ao Terminals - Pioneer PE6000 Series User Manual

PE6000 User Manual
the voltage or current and actual setting or feedback is defined by P4-13 to P4-27.
P3-29: AI curve selection
The user can preset
up to 5 curves.
Different AIs can
use one curve.
The sampling of AI terminals can be queried in U0-09 to U0-11. The calculation value is for
internal subsequent calculation and cannot be directly read by the user.

3.12 Use of AO Terminals

The AC drive supports one AO terminal, and AO1 is provided by the control board.
Terminal
AO1-GND
AO1 can be used to indicate the internal running parameters in the analog mode.
The property of indicated parameters can be defined by P5-07 and P5-08.
The designated running parameters can be rectified before output. The rectification feature is The designated running parameters can be rectified before output. The rectification feature is
Y = kX + b, among which "X" indicates the running parameters to be output, and "k" and "b" of , among which "X" indicates the running parameters to be output, and "k" and "b" of
AO1 can be set by P5-10 and P5-11.
Curve 1: P4-13 to
P4-17
Unit's digit: AI1
Curve selection: 1-5
Ten's digit: AI1
Curve selection: 1-5
If J5 is connected to the position with "V" mark, it outputs the signal of If J5 is connected to the position with "V" mark, it outputs the signal of
0–10 VDC. If J5 is connected to the position with "I" mark, it outputs the
signal of 0–20mA.
P
Operation, Display and Application Examples Operation, Display and Application Examples
Curve 2: P4-18 to
P4-22
11. The calculation value is for
Output Signal Characteristic
P
41
Curve 5: A6-09 to 09 to
A6-15
AI1 internal
calculation value
AI2 internal
calculation value
, it outputs the