Figure 84. Install the NDC riser
Next steps
1. Connect the cables to the NDC riser.
2. Follow the procedure listed in
Network daughter card
Removing the NDC
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the Network Daughter Card (NDC)
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the NDC to the NDC riser.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the NDC riser.
3. Slide the NDC away from the NDC riser bracket until the Ethernet connectors are clear of the slot in the NDC riser.
100
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 30.
on page 29.
on page 30.