Installing An Intrusion Switch - Dell EMC PowerEdge R940 Installation And Service Manual

3. Press the tab on the intrusion switch cable connector and disconnect the cable connected to the intrusion switch connector
(INTRUSION) on the system board.
4. Remove the cables routed through the cable routing hooks on the right side of the system.
5. Push the intrusion switch out of the intrusion switch slot.
Figure 36. Removing an intrusion switch
Next steps
Install an intrusion switch.

Installing an intrusion switch

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Slide the intrusion switch into the intrusion switch slot.
2. Route the cables through the cable routing hooks on the side of the system.
3. Lower the cable management bracket into the system.
4. Press the bracket and insert the tabs on the bracket into the slots on the right side of the system.
5. Connect the cable to the connector (INTRUSION) on the system board.
Safety instructions
Before working inside your system
on page 29.
on page 30.
Installing and removing system components 47