Figure 90. Installing the MicroSD card
Next steps
1. Follow the procedure listed in
Optional IDSDM or vFlash module
Removing the optional IDSDM module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If you are replacing the IDSDM module,
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
1. Locate the IDSDM module connector on the system board.
To locate IDSDM module connector, see the
2. Holding the pull tab, lift the IDSDM module out of the system.
106
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
remove the MicroSD
System board jumpers and connectors
on page 30.
on page 29.
on page 30.
cards.
section.