Figure 86. Installing the NDC
Next steps
1.
Install the NDC
riser.
2. Follow the procedure listed in
Storage controller card
Removing the storage controller card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the Network Daughter Card (NDC)
Steps
1. Slide the riser retention bracket to unlock the storage controller card.
2. Hold the storage controller card by its edges and lift to remove it from the connector on the system board.
3. Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
102
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 30.
on page 29.
on page 30.