Installing The Pem Power Board - Dell EMC PowerEdge R940 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge R940:
- Installation and service manual (161 pages) ,
- Technical manual (51 pages) ,
- Service (14 pages)
Table of Contents
Advertisement
Figure 71. Removing the PEM power board
Next steps
Install the PEM power
board.
Installing the PEM power board
Prerequisites
1. Follow the safety guidelines listed in
Safety instructions
on page 29.
2. Follow the procedure listed in
Before working inside your system
on page 30.
Steps
1. Hold the PEM power board by its edges, position the power board so that the power board connector aligns with the
connector on the system board.
2. Insert the power board into the connector on the system board until the power board is fully seated.
86
Installing and removing system components
Advertisement
Table of Contents
