Installing The Right Control Panel - Dell EMC PowerEdge R940 Installation And Service Manual

NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
7. Press the blue release tabs on the fan tray and lower the sides of the tray.
Steps
1. Press the cable management bracket until the tabs on the bracket disengage from the slots on the right side of the system
and lift the cable management bracket from the system.
2. Holding the pull tab, disconnect the control panel cable from the system board.
3. Using a Torx #T30 screwdriver, remove the screws that connect the control panel to the system.
4. Holding the control panel by its sides, remove the control panel away from the system.
Figure 105. Removing the right control panel
Next steps
Install the right control panel.

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Route the cables through the cable routing hooks on the side of the system.
2. Lower the cable management bracket into the system.
3. Press the bracket and insert the tabs on the bracket into the slots on the right side of the system.
Safety instructions
Before working inside your system
on page 29.
on page 30.
Installing and removing system components 123