Pem Power Board; Removing The Pem Power Board - Dell EMC PowerEdge R940 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge R940:
- Installation and service manual (161 pages) ,
- Technical manual (51 pages) ,
- Service (14 pages)
Table of Contents
Advertisement
Figure 70. Cable routing - Two processor system
1. system board
2. UPI cable connecting RM_UPI_A and RM_UPI_D connectors on system board
3. UPI cable connecting RM_UPI_C and RM_UPI_B connectors on system board
NOTE:
This is only applicable for using Intel Processor 61xx, 62xx, 81xx and 82xx series.
PEM power board
Removing the PEM power board
Prerequisites
1. Follow the safety guidelines listed in
Safety instructions
on page 29.
2. Follow the procedure listed in
Before working inside your system
on page 30.
3.
Remove the air
shroud.
4. Lift the PEM by using the PEM handle until the PEM is in an upright position.
Steps
Hold the PEM power board by its edges and remove the power board from the connector on the system board.
Installing and removing system components
85
Advertisement
Table of Contents
