Installing The Processor Into A Processor And Heat Sink Module - Dell EMC PowerEdge R940 Installation And Service Manual

Figure 61. Loosening the processor bracket
4. Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor
tray.
5. Flex the outer edges of the bracket to release the bracket from the processor.
NOTE: Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 62. Removing the processor bracket
Next steps
Install the processor into the processor and heat sink module.

Installing the processor into a processor and heat sink module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Safety instructions
Before working inside your system
on page 29.
on page 30.
Installing and removing system components 77