Removing The Drive From The Drive Carrier - Dell EMC PowerEdge R940 Installation And Service Manual

CAUTION: When a replacement hot swappable drive is installed and the system is powered on, the drive
automatically begins to rebuild. Ensure that the replacement drive is blank or contains data that you wish to
overwrite. Any data on the replacement drive is immediately lost after the drive is installed.
1. Follow the safety guidelines listed in
2. If installed, remove the drive
Steps
1. Press the release button on the front of the drive carrier to open the release handle.
2. Insert the drive carrier into the drive slot and slide until the drive connects with the backplane.
3. Close the drive carrier release handle to lock the drive in place.
Figure 41. Installing a drive carrier
Next steps
If removed, install the front

Removing the drive from the drive carrier

Prerequisites
Follow the safety guidelines listed in
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
Safety instructions
blank.
bezel.
Safety instructions
on page 29.
on page 29.
Installing and removing system components 51