Optional Internal Usb Memory Key; Replacing The Optional Internal Usb Memory Key - Dell EMC PowerEdge R940 Installation And Service Manual

2. Use a plastic scribe to pry out the system battery as shown in the illustration below.
Figure 100. Removing the system battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 101. Installing the system battery
Next steps
1. If removed, install the
2. If removed, install the expansion card
3. If applicable, connect the cables to the expansion card(s).
4. Install the air shroud.
5. Follow the procedure listed in
6. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
7. Enter the correct time and date in the System Setup Time and Date fields.
8. Exit the System Setup.

Optional internal USB memory key

Replacing the optional internal USB memory key

Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
116 Installing and removing system components
PEM.
risers.
After working inside your system
Safety instructions
Before working inside your system
System board jumpers and
on page 30.
on page 29.
on page 30.
connectors.