Installing The Ndc - Dell EMC PowerEdge R940 Installation And Service Manual

Figure 85. Removing the NDC
Next steps
1. Install the NDC.

Installing the NDC

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Orient and slide the NDC so that the Ethernet ports fit through the slot in the NDC riser.
2. Align the captive screws on the card with the screw holes on the NDC riser.
3. Press the touch points on the card until the connector connects with the connector on the NDC riser.
4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the NDC riser.
Safety instructions
Before working inside your system
on page 29.
on page 30.
Installing and removing system components 101