Removing Expansion Card Riser Blank; Installing Expansion Card Riser Blank - Dell EMC PowerEdge R940 Installation And Service Manual

Removing expansion card riser blank

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
Hold the expansion card riser blank and lift the blank out of the system.
NOTE: When you upgrade your system from two processor configuration to four processor, ensure that you remove the
riser blanks from the system.
Figure 73. Removing expansion card riser blank
Next steps
Install the expansion card riser

Installing expansion card riser blank

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
Lower the expansion card riser blank into the system until the blank is seated on the corresponding slot at the back of the
system.
90 Installing and removing system components
Safety instructions
Before working inside your system
blank.
Safety instructions
Before working inside your system
on page 29.
on page 30.
on page 29.
on page 30.