Installing The Left Control Panel - Dell EMC PowerEdge R940 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge R940:
- Installation and service manual (161 pages) ,
- Technical manual (51 pages) ,
- Service (14 pages)
Table of Contents
Advertisement
Steps
1. Holding the pull tab, disconnect the control panel cable from the connector on the system board.
2. Using a Torx #T30 screwdriver, remove the screws that secure the left control panel to the system.
3. Holding the control panel by its sides, remove the control panel away from the system.
Figure 107. Removing left control panel
Next steps
Install the left control
panel.
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in
Safety instructions
on page 29.
2. Follow the procedure listed in
Before working inside your system
on page 30.
Steps
1. Route the control panel cable through the side wall of the system.
2. Align the control panel with the control panel slot on the system and attach the control panel to the system.
3. Connect the control panel cable connector on the system board.
4. Using a Torx #T30 screwdriver, install the screws that secure the control panel to the system.
Installing and removing system components
125
Advertisement
Table of Contents
