Removing The Left Control Panel - Dell EMC PowerEdge R940 Installation And Service Manual

4. Align the control panel with the control panel slot on the system and attach the control panel to the system.
5. Connect the control panel cable connector on the system board.
6. Using a Torx #T30 screwdriver, install the screws that secure the control panel to the system.
Figure 106. Installing the right control panel
Next steps
1. Lift the sides of the fan tray until the blue release tabs click in place.
2. If removed, install the expansion card risers
3. If removed, install the
4. Install the air shroud.
5. Install the fan cage.
6. Follow the procedure listed in

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the fan cage.
4. Remove the air shroud.
5. If installed, remove the expansion card
6. If installed, remove the
NOTE: Ensure that you note the routing of the cables as you remove them from the system. You must route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
7. Press the blue release tabs on the fan tray and lower the sides of the tray.
124 Installing and removing system components
PEM.
After working inside your system
Safety instructions
Before working inside your system
risers.
PEM.
on page 30.
on page 29.
on page 30.