M.2 Ssd Module; Removing The M.2 Ssd Module - Dell EMC PowerEdge R940 Installation And Service Manual

NOTE: This step is applicable only if you are installing the expansion cards in the slots 12 and 13 of Riser 3 (IO_RISER3)
and slots 9 and 10 of Riser 2(IO_RISER2).
5. Close the PCIe card latch.
Figure 80. Installing expansion card into expansion card riser
Next steps
1. Install the expansion card
2. Connect the cables to the expansion card.
3. Follow the procedure listed in

M.2 SSD module

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the BOSS card.
NOTE: Removing the BOSS card is similar to the procedure for
Steps
1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
2. Pull the M.2 SSD module away from the BOSS card.
96 Installing and removing system components
riser.
After working inside your system
Safety instructions
Before working inside your system
on page 30.
on page 29.
on page 30.
removing an expansion card riser.