HP 8340B Manual page 132

3.4
HP-IB
Addresses of the Test Equipment
The Attenuator Calibration and Operation Verification test software has been written to drive
specific
HP-IB test equipment Although the test equipment
which
Is required can not be
changed, the HP-IB addresses for the
test equipment
can be modified Table 2
below lists the
test equipment
with HP-IB
and the
equipment's HP-IB addresses. Use of the HP-IB
addresses shown below will
not require any
modification of the
software.
If
you wish to use
different addresses than shown, you will need to
modify the software- For the HP-IB address
modification procedure, refer to paragraph
35
Table
2
HP-IB
Address
Settings/or the Test Equipment
Model Number
HP 2673A or 2225A
HP
5343A
HP 3585A
HP 436A
HP5316A
HP8340A/Bor8341A/B
HP 8340A/B
Description
Printer
Frequency Counter
Spectrum Analyzer
Power Meter
Universal Counter
Device Under Test
Local Oscillator
HP-IB Address
01
02
11
13
16
19
20
3.5
Modifying the HP-IB Addresses of the Test Equipment
Located
in
the overhead program FS—MANAGER, subprogram
Asgn_test_equip, are
the
assignments
of
the HP-IB addresses for the test
equipment used
in
the test software. Figure
2
provides
a
listing of the subprogram Asgn_test_equlp and the current
HP-IB address
assign¬
ments. Included in
the test
equipment assignments are some
additional pieces of test
equip¬
ment which are
not needed to run the HP
8340A/B and HP 8341A/B
Attenuator Calibration
and Operation Verification Test Software You
only
need to modify the HP-IB address
assign¬
ments
for the test equipment listed In Table
2
The procedure for modifying the test equip-
ment's HP-IB address assignments is described below
In
PERFORMING THE
MODIFICATION-
HP 8340A/B
and
HP 8341A/B
How to Configure the Software