HP 8340B Manual page 178

Chapter 4. Test Dependence
INTRODUCTION
Table
4-1 lists
the tests
provided in
the test software. The table is divided into the
tests available when
you select the operation verification softkey and those available when you select the
attenuator
calibration softkey.
Table
4-1.
Listing
of Tests
Operation Verification
Attenuator Calibration
Cal Constants
Phase Lock Diagnostics
CW Frequency
Accuracy
ALC Accuracy
Output Power Accuracy
Maximum Leveled Power
Output Power Accuracy
RF Attenuator Calibrate
Frequency Switching Time
Cal Constants
Some
tests require that the user
generated
calibration data for the
HP 8485A power sensor and
the
HP 355D step attenuator (IF attenuator) be on
the disc assigned to hold
this
information.
In addition,
some tests must be
run
in
sequence
to allow the measurement data obtained during one test to be
used for
a
later test. Table
4-1 is
a
test dependence flow chart that shows the test hierarchy. See
chapter
3
for information on the software's mass and data storage addressing
(i.e.
on
which
disc the
user generated
calibration data and the measurement data resides).
Attenuator Calibration and Operation Verification Test Software
Test Dependence