HP 8340B Manual page 168

When
copying HP part number 08340-10009
onto another 3.5
inch,
double sided microfloppy, you
must specify the interleave factor and also the
format
to be used during initialization
of your blank
disc.
The required
interleave factor
is
2
and the required format
is
3
(1024 bytes/sector). The
initialize
command to
execute from your computer's keyboard
is:
INITIALIZE "Address
of the disc drive containing your
blank floppy ",2,3
Example: INITIALIZE ":,700,1",2,3. This
initializes
a
disc
at HP-IB address 700, drive
1
and sets the
disc's interleave factor to
2
and
format to 1024 bytes/sector.
If
you do not initialize your blank 3.5
inch,
double sided microfloppy in this
manner, you
will not
have sufficient
space on the disc to copy the
software!
NOTE:
You can only copy HP part number 08340-10009
to either
a
fixed disc drive with
>- 750
Kbytes of storage, or
another 3.5
inch,
double
sided disc that has been initialized as described above.
ANOMALY REPORTING
As with any software, an anomaly may occur.
If
you observe a
software anomaly,
notify the nearest
Hewlett-Packard sales and service office. Use the software
notification
form at the end of
this
manual.
SOFTWARE SUPPORT INFORMATION
The software support provided by Hewlett-Packard
for the attenuator calibration and operation
ver¬
ification
test software,
is
limited to the correction of anomalies found while using this
test software
with the test
equipment recommended in section
2
of this document. Any deviation from the recom¬
mended
equipment is
not supported by
Hewlett-Packard.
The software modifications that the operator is
allowed to perform are limited to the
mass storage
address, data storage address, and the
test equipment address modifications described in
section
3
of this document. Modifications made to the software beyond those described
in section
3
are
not
supported by Hewlett-Packard.
Attenuator Calibration and Operation Verification Test Software
General Information 1-3/1-4