HP 8340B Manual page 169

Chapter
2.
Required Test Equipment
INTRODUCTION
This section provides
a
comprehensive
list of test equipment and accessories required to perform the
tests in
this
software.
Also provided
is
the system controller (technical computer, disc drive, and
operating system) requirements.
TECHNICAL COMPUTER
Technical Computer:
HP 9836A (HP 236)
with s: 1
megabyte of
memory.
The software
is
also
directly
compatible with the
other HP
9000
Series
200
technical computers
(with
the exception of the
HP Model 217
and 237)
if
they have 2:1
Mbyte of memory.
If
you wish to use an
HP 9000 series 300 computer,
the software
is
compatible with the HP 98580A
and 98581
A
systems.
DISC DRIVE
Disc Drive:
HP 9133H or HP 9153A
The critical requirement of the disc drive used
to run the performance software is
that the disc drive
Is
compatible with both the
HP 9000 Series 200 or Series 300
technical
computer
you use, and the media
you use to run the
software.
The HP 9133H
and
9153A
are recommended because they eliminate the need to interchange test
software
discs,
reducing
the
operator interaction, test time, and the potential for error while
running
the software.
These
disc drives also provide additional storage capability for other
software
you may
have.
They allow convenient storage of the test data on either the fixed disc or
a 3.5
inch floppy, and
simplify the task
of making
a
working copy of the test
software.
Although use of
a
fixed disc drive
is
recommended,
if
you
decide to use the
software on the media
provided, the recommended disc drives are:
•
HP part number 08340-10009
-
HP 9122D
•
HP part number 08340-10011
-
HP 9122D or
HP 9121 D
•
HP part number
08340-10012
-
Internal disc drives provided on the HP
9836A.
Attenuator Calibration and Operation Verification Test Software
Required Test Equipment 2-1