HP 8340B Manual page 179

TEST DEPENDENCE FLOW CHART
The
flow chart in Figure
4-1
shows test interdependence. As shown
in
the flow
chart, you
must
perform the power sensor cal, level
1
before you run the
output power accuracy test,
level 2, and that
you must perform
the IF
attenuator
cal, level
1
before you run the low output
power accuracy
test,
In
addition,
you must perform the output power accuracy test before
you run
the tests in level 3.
The tests listed in Table
4-1
but not included in the flow chart may be performed in
any order.
LEVEL
1
Power Sensor
Cal
( CQl
Utility
Softkey)
IF
Attenuator
Cal
( Cal
Utility
Softkey)
LEVEL 2
Output
Power Accuracy
LEVEL
3
Maxim
Leveled
um
Power
RF
Attenuator
Calibration
Figure 4-1. Test
Dependence
Flow Chart
Test Dependency
Attenuator Calibration and Operation Verification Test Software