Mitsubishi Electric FR-A700 Instruction Manual page 148

Simple mode parameter list
Display during tuning
Monitor is displayed on the parameter unit (FR-DU07/FR-PU04/FR-PU07) during tuning as be-
low. The monitored value is the value of parameter 96..
Pr. 96
Setting
Tuning in
progress
Normal end
Error end
(when inverter
protective func-
tion operation is
activated)
Tab. 5-4: Display during tuning (monitor display)
Offline Auto Tuning Setting
Non-rotation mode (Pr. 96 = 1)
Rotation mode (Pr. 96 = 101)
Tab. 5-5: Offline auto tuning time (when the initial value is set)
Return to normal operation
When offline auto tuning ends, press the STOP/RESET key of the operation panel during PU op-
eration. For external operation, turn off the start signal (STF signal or STR signal). This oper-
ation resets the offline auto tuning and the PU's monitor display returns to the normal indication.
(Without this operation, next operation cannot be started.)
NOTE Do not change the Pr. 96 setting after completion of tuning (3 or 103). If the Pr. 96 setting is
changed, tuning data is made invalid. If the Pr. 96 setting is changed, tuning must be per-
formed again.
5 - 28
Parameter unit
FR-PU07/FR-PU04 Display
1 101
Parameter unit
FR-DU07 Diesplay
1
Flickering
Time
Approximately 25 to 120s
(Tuning time differs according to the inverter capacity
and motor type.)
Approximately 40s
(Offline auto tuning time varies with the acceleration and
deceleration time settings as indicated below. Offline
auto tuning time = acceleration time + deceleration time
+ approx. 30s)
Basic settings
101
Flickering