Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 989

22B-24
MANUAL TRANSMISSION OVERHAUL -
Oil seal
MD998801
Snap ring
Synchronizer spring
3rd
speed
side
Identification mark
REASSEMBLY SERVICE POINTS
"AA OIL SEAL INSTALLATION
3.5 mm
Accurately tap in the oil seal to the dimensions shown in
the illustration.
"BA BALL BEARING INSTALLATION
MD998812
Using the special tool, install the ball bearing onto the input
shaft.
MD998813
MD998818
"CA SNAP RING INSTALLATION
Select and install the snap ring so that the input shaft front
bearing clearance is at the standard value.
Standard value: 0.01 mm tight to 0.12 mm loose
"DA SYNCHRONIZER SPRING INSTALLATION
Accurately install the synchronizer spring onto the position
of the synchronizer ring shown in the illustration.
"EA 3RD-4TH SPEED SYNCHRONIZER HUB
Installation
direction
Install the 3rd-4th speed synchronizer hub onto the input
4th speed
shaft at the direction shown in the illustration.
side
Input Shaft
INSTALLATION