Windshield Wiper And Washer; Service Specifications; Troubleshooting; On-Vehicle Service - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

WINDSHIELD WIPER AND WASHER

SERVICE SPECIFICATIONS

Item
Stop position of the windshield wiper arm/blade assembly (distance between the edge of Stop position of the windshield wiper arm/blade assembly (distance between the edge of
the wiper blade and the end of the deck garnish) mm

TROUBLESHOOTING

The windshield wiper-washer is controlled by the smart wiring system (SWS). Refer to Group 54B for
troubleshooting.
NOTE
If ETACS-ECU is faulty, the windshield wiper can be operable in LO mode only as the fail - safe function.
(Normally the windshield wiper is operable when the ignition switch is turned to the ACC position. When
the fail - safe function is enabled, it is operable only when the ignition switch is turned to the ON position.)
EXTERIOR -
Windshield Wiper and Washer

ON-VEHICLE SERVICE

WINDSHIELD INTERMITTENT WIPER
INSPECTIONS
(1) Check the change in the intermittent time of the wiper
(2) Carry out troubleshooting if any of them is faulty.
operation by using the windshield intermittent wiper
volume.
(Refer to Group 54B.)
51-13
Standard value
34 34 5 5
± ±